HIKVISION DS-2DP1636Z-D User Manual page 66

 Pre-record: The time you set to start recording before the scheduled time or the event. For
example, if an alarm triggers recording at 10:00, and the pre-record time is set as 5
seconds, the camera starts to record at 9:59:55.
The Pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or
not limited.
Note:
The pre-record time changes according to the video bitrate.
 Post-record: The time you set to stop recording after the scheduled time or the event. For
example, if an alarm triggered recording ends at 11:00, and the post-record time is set as 5
seconds, the camera records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min or 10 min.
Note:
The Pre-record and Post-record parameters vary depending on different camera models.
 Stream Type: You can select the stream type for recording; Main stream, sub stream and
third stream are selectable. If you select the sub stream, you can record for a longer time
with the same storage capacity.
4. Click OK to save the advanced setting.
5. Set the record schedule:
(1) Select a Record Type. The record type can be Continuous, Motion, Alarm, Motion | Alarm,
Motion & Alarm, and Events.

Continuous
If you select Continuous, the video will be recorded automatically according to the time
of the schedule.
 Record Triggered by Motion Detection
If you select Motion, the video will be recorded when the motion is detected.
Besides configuring the recording schedule, you have to set the motion detection area
and check the Trigger Channel checkbox in the Linkage Method of Motion Detection
settings interface. For detailed information, refer to the Step 1 in the Section 6.1.1
Configuring Motion Detection.

Record Triggered by Alarm
If you select Alarm, the video will be recorded when the alarm is triggered via the
external alarm input channels.
User Manual of PanoVu Series Network Camera
Figure 5-7 Record Schedule
59