Install The System In The Rack - EMC CloudBoost 100 Installation And Setup Manual

Installation and Setup Guide

Install the system in the rack

EMC CloudBoost 100 2.0 Installation and Setup Guide
16
Figure 15 Attach bracket to front of rack
1. Hole for top register pin on the system.
2. Hole for captive screw on the system.
3. Add a second, optional screw to secure the system.
4. Attach the rail to the rack using a provided screw.
5. Hole for bottom register pin on the system.
Note
The optional screw is used to secure the system to the rack if it is necessary to
move the rack.
8. Verify that the bracket is level.
9. Repeat the steps to attach the remaining bracket to the other side of the rack.
10. After installing both brackets, make sure that they are level with one another.
CAUTION
This procedure requires two people or a mechanical lift.
Procedure
1. With the system in the front of the rack, orient the system correctly with the
rack. Carefully lift the system to engage the rack at the required height.
2. Align the rear of the chassis with the lip of each installed rack bracket.
3. Carefully slide the chassis all the way into the rack.
4. At the front, attach the system to each installed bracket using the two captive
screws on the front of the system.