Table of Contents
Advertisement
The MAP-2105 should connect to the network that provide DHCP services (the first time
installation) In this guide, we will base on XRT-401D (Internet Broadband Router) as the example
for DHCP server, switch and router, this installation can vary on the network planning.
The MAP-2105 should be installed in the same subnet to the Mesh Gateway for optimal
performance.
The MAP-2105 is optimized for 500-user registration; however, the overall
network performance may vary on the real environment and application in
Note
many aspects, such as the bandwidth to the Internet, the services / sessions
that the clients implement.
1.4 Hardware Installation
1. Using Category 3 or higher UTP or STP cable, connect the WAN port of MAP-2105 to a
10Mbps or 10/100Mbps Ethernet hub or switch, and connect the management station to a
hub or switch on the same LAN.
2. Connect the power adapter to the receptor on MAP-2105 and plug the other end to a wall
outlet or power strip.
ONLY use the power adapter supplied with the MAP-2105. Otherwise, the
product may be damaged.
Note
1.5 Startup the MAP-2105
To get the first management of the MAP-2105, please follow the following steps.
1. Connect the MAP-2105's WAN port to the network where can provide the DHCP services.
For example, connect to the LAN port of XRT-401D.
2. Power on a PC that also connects to the LAN port of the XRT-401D with DHCP or fixed IP
address.
3. Open the Internet browser and go to the DHCP status page of XRT-401D to check the WAN
IP address of the MAP-2105.
4. Check the MAC address from the Web page and also the MAC address label of the MAP-
2105. For example, 09-64 as the figure above.
5. Key in the IP address you found for MAP-2105 with "https://". For example:
WAN MAC Address of
MAP-2105
2
Advertisement
Table of Contents
