Custom Parameter - SCC MAM–200 Operation Manual

1.5 Custom parameter

1.5.1
Customer Parameter View and Modification
CUSTOMER PARAMETER and FACTORY PARAMETER
are not allowed to be modified in running and stop delay status.
When modifying Customer parameter please refer to run parameter modification method. The modification
process of LOADING P is showing as an example below:
Press or
menu
Move the cursor to "SET P, T", press
User can check the CUSTOMER PARAMETER in this menu or press
requires an user password input
NOTE: Customer password can be set in CUSTOMER PARAMETER
and FACTORY PARAMETER is fixed as ____________
04.08.2017
to move the cursor to "CUSTOMER PARAMETER", then press
SET P、T
ON/OFF DELAY PRESET
OP. MODE PRESET
BLCK PARA PRESET
to switch to secondary menu:
LOADING P:
UNLOADING P: 0.6MPa
FAN START T:
FAN STOP T：
ENTER PASSWORD
Operation Manual MAM - 200 V1.0
0.8MPa
80℃
70℃
****
to switch to secondary
to switch to the following menu which
8