1.
Risk of damage to the remote
The maximum torque to tighten the screw
is 1 Nm.
– Do not exceed this rating as it may damage
the remote.
Set remote D in clamp A and tighten screw B and
washer C with nut E.
2. Pull clamp bracket G over nucleus F.
3. Attach clamp A to clamp bracket G and fix everything
with screws H.
3.10.3 Mounting the DLX-REM050
•
4 mm Allen key
•
3 mm Allen key
The attendant control unit is fitted to the wheelchair using a
bracket on the push handle or the push bar.
1. Pull screws A through washers B, mounting plate C
and bottom side of bracket D.
2. Tighten bottom side of the bracket to push bar with the
top side of the bracket E and nuts F.
3.
Pull screws G through washers H bracket I and
attendant control unit.
4. Tighten screws.
5. Connect attendant control unit.
1605129-C
Mounting positions
3.11 Mounting the ASL components
For more information about how remote holders
are mounted to the wheelchair, refer to the service
manual of the seating system.
3.11.1 Mounting the Compact Single Switch Joystick
Lateral tray mount
•
1/8" Allen key
•
5/32" Allen key
•
3/16" Allen key
Assembly
33