Fujitsu IP-HE950 Hardware User's Manual page 82

IP-HE950 Hardware User's Guide
LED name
PWR
G Power on
O Abnormal unit
RDY
G Operating normally
O Maintenance mode
LAN1
(IP=10.0.0.1)
LAN2
(IP=192.168.255.253)
ALM
O Unit alert generated
INDWN
O Video, audio, or network
system input down/fault
LINK/ACT
G LINK established
[LAN1]
100/1000M
G 100BASE operation
[LAN1]
LINK/ACT
G LINK established
[LAN2]
100/1000M
G 100BASE operation
[LAN2]
G: Green, O: Orange
Name
Power
Table A.2-4 LED interface specifications
On
Table A.2-5 Switch interface specification
Switch type
Rocker switch Turn on (–)/off (O)
Blinking
--- Power off
Software starting Software inactive
up normally
Software starting
up in maintenance
mode
Unit alert Normal operation
generated
Video, audio, or Normal operation
network system
input down/fault
LAN packet Cable link down or
detected cable disconnected
1000BASE 10BASE operation
operation
LAN packet Cable link down or
detected cable disconnected
1000BASE 10BASE operation
operation
Specification
68
Off
Hardware operation
Abnormal temperature, power
error, or fan error
Blink interval: 0.5 seconds
Maintenance mode
(Startup with CANCEL button)
LAN1 subnet mask
(255.0.0.0)
LAN2 subnet mask
(255.255.255.252)
You can change settings for
some alerts to turn on, blink, or
turn off the LED when a unit alert
is generated.
You can change settings to turn
on, blink, or turn off the LED,
except to turn on the LED due to
an abnormal temperature.
Behavior
Copyright 2017 FUJITSU LIMITED
Appendix
Remarks