Fujitsu IP-HE950 Hardware User's Manual page 21

IP-HE950 Hardware User's Guide
(4)
(5)
Direction keys
()
(6)
(7)
ENTER key
(8)
(ENTER)
CANCEL key
(9)
(CANCEL)
Power LED
(10)
(PWR)
Status LED
(11)
(RDY)
Video input status LED
(12)
(INDWN)
Alarm LED
(13)
(ALM)
(14) Power switch
(15) AC cord clamp
(16) Power inlet connector
(17) Fan
FG terminal
(18)
(FG)
ETHERNET port 2 for
(19) LAN connection
(LAN2)
Status LED
(20)
(LINK/ACT)
Speed LED
(21)
(100/1000M)
DVB-ASI output
(22)
(ASI-OUT1)
DVB-ASI output
(23)
(ASI-OUT2)
External audio input
(24)
(AUDIO)
Used to operate the Front panel.
For instructions, refer to the IP-HE950 Software User's Guide.
Used to finalize the displayed data on the Front panel.
For instructions, refer to the IP-HE950 Software User's Guide.
Used to cancel the displayed data on the Front panel.
For instructions, refer to the IP-HE950 Software User's Guide.
Goes on when this unit is powered on.
LED that shows the operating status of the IP-HE950. The LED
light color is green when operation is normal.
For details, refer to "Table 5-3 LED indications" in Section 5.2.
Turns on or blinks when input is abnormal (input down/input
error).
For details, refer to "Table 5-3 LED indications" in Section 5.2.
Turns on or blinks when operation is abnormal.
For details, refer to "Table 5-3 LED indications" in Section 5.2.
Powers on/off this unit with 100-240 VAC. For instructions, refer
to "3.1 Turning On/Off the IP-HE950."
AC cord clamp for fixing the power cord in place. For instructions,
refer to "2.2.2 Connection to a power source."
Can be connected to a 100-240 VAC commercial power supply
by a power cord with a standard two-prong plug with ground.
For instructions, refer to "2.2.2 Connection to a power source."
For cable connection information, refer to "4.2 Cable and
Connector Details."
Maintenance-free fan for cooling the inside of the unit.
Used to connect FG to this unit when required.
For instructions, refer to "2.2.1 Connection to ground."
10BASE-T/100BASE-TX/1000BASE-T communication port.
For instructions, refer to "2.6 Connection to LAN Equipment." For
cable connection information, refer to "4.2 Cable and Connector
Details."
LED that shows the status of LAN port 2. For details, refer to
"Table 5-3 LED indications" in Section 5.2.
LED that shows the speed of LAN port 2. For details, refer to
"Table 5-3 LED indications" in Section 5.2.
DVB-ASI output connectors. Output is 75 Ω unbalanced output.
For instructions, refer to "2.5 Connection to DVB-ASI Equipment."
For cable connection information, refer to "4.2 Cable and
Connector Details."
External audio input connector supported in the future. This is
disabled now.
7
Chapter 1 Preparations
Copyright 2017 FUJITSU LIMITED