Install The Adjustable Power Supply Retainer - Cisco ASA 5506W-X Hardware Installation Manual

Maintenance and Upgrades

Install the Adjustable Power Supply Retainer

You can install an adjustable power supply retainer for the Delta and LiteOn power supplies in the rack-mount
tray. The bracket kit contains the bracket, 2 M3 screws, and washers. The following figure shows the adjustable
retainer.
Figure 32: ASA Bracket Assembly
1
Step 1 Slide the rack-mount shelf containing the ASA(s) out of the rack.
Step 2 At the back of the rack-mount shelf behind the power supplies, install the adjustable retainer.
a) Loosen the 2 top screws (item 1 in the figure above) slightly to adjust the bracket for each power supply.
The Delta power supply uses the bracket extended to its tallest configuration. This configuration has item 1 shifted
to the bottom of the slot on the bracket over the power supply. The LiteOn power supply uses the bracket extended
to its shortest configuration. This configuration has item 1 shifted to the top of the slot on the bracket over the power
supply.
b) Install the bracket over the power supply and screw the 2 bottom M3 captive screws (item 2 in the figure above) on
each side of the bottom of the bracket into the rack-mount tray.
Online Only
Two screws to loosen to change
from high to low bracket
Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide
Install the Adjustable Power Supply Retainer
2 Two captive screws to attach to
rack-mount tray
47