Connect Cables, Turn On Power, And Verify Connectivity - Cisco ASA 5506W-X Hardware Installation Manual

Mount and Connect
The chassis is now installed in the DIN rail.
What to Do Next
See Connect Cables, Turn on Power, and Verify Connectivity, on page 37

Connect Cables, Turn on Power, and Verify Connectivity

After positioning or mounting the ASA, follow these steps to connect cables, turn on power, and verify
connectivity:
Step 1
Connect the network cables:
a) Management interface – Using this Management 1/1 Gigabit Ethernet port, you can connect a management computer
directly with an Ethernet cable, or you can connect the computer and the ASA to the same management network. Be
sure the PC is configured to obtain an IP address using DHCP.
You can configure any of the Gigabit Ethernet interfaces to be a management-only interface using the
management-only command. However, you cannot disable management-only mode on the Management 1/1 interface.
The following figure shows how to connect the network cables.
Figure 27: ASA 5506-X and ASA 5506W-X Cabling
Online Only
Connect Cables, Turn on Power, and Verify Connectivity
Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide
to finish setting up your ASA.
37