Service Position: Lcd Module; Service Position To Check The Vtr Section - Sony DCR-IP1 Service Manual

DCR-IP1/IP1E

[SERVICE POSITION: LCD MODULE]

ACX510CMN-J (LCD901)
PD-199 board
AC power adaptor
AC IN
Adjustment remote commander (RM-95)
2-3

[SERVICE POSITION TO CHECK THE VTR SECTION]

Connection to Check the VTR Section
To check the VTR section, set the VTR to the "Forced VTR power ON" mode.
Operate the VTR functions using the adjustment remote commander (with the HOLD switch set in the OFF position).
Setting the "Forced VTR Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 02 and
press the PAUSE button of the adjustment remote
commander.
Note: Although the following message is displayed when a power supply is switched on,
it is because the front panel is removed and this is normal.
Lens cover is not closed. Turn the power on again.
Cabinet R block assembly
FP-732
Lens block assembly
IF-108 board
CN107 (No Mount)
CPC
Mechanism deck
Exiting the "Forced VTR Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, data: 00, and press the PAUSE
button of the adjustment remote commander.
3) Select page: 0, address: 01, and set data: 00.
AC IN
AC power adaptor
Adjustment remote commander
(RM-95)
flexible board
FP-722 flexible board
To eject the cassette, short the circuit between
Pin 0 and between Pin qa (GND) pattern on
IF-108 board of CN2604 for 1 second.
IF-108 board
CN2604
10
11
VC-333 board
Procedure of removing mechanism deck (Mechanism deck service position)
1 2-1. Top cabinet assembly ............................................. (PAGE 2-5)
2 2-2. F panel block assembly .......................................... (PAGE 2-5)
3 2-5. Cabinet R block assembly ...................................... (PAGE 2-7)
4 2-6. FP-732/FP-734 flexible board ................................. (PAGE 2-7)
5 2-10. IF-108 board ......................................................... (PAGE 2-11)
6 2-11. SE-139 board, Mic unit ......................................... (PAGE 2-11)
7 2-12. Lens block assembly ............................................ (PAGE 2-12)
8 2-14. Cabinet G ............................................................. (PAGE 2-13)
9 2-15. Cabinet L assembly .............................................. (PAGE 2-13)
q; 2-16. VC-333 board ....................................................... (PAGE 2-14)
qa 2-17. Mechanism deck ................................................... (PAGE 2-14)
2-4