Sony DCR-IP1 Service Manual page 9

Self-diagnosis Code
Block Detailed
Function Code
E 6 1 0 0 Difficult to adjust focus
(Cannot initialize focus.)
Zoom operations fault
E 6 1 1 0
(Cannot initialize zoom lens.)
Steadyshot function does not work well.
E 6 2 0 0 (With pitch angular velocity sensor output
stopped.)
Steadyshot function does not work well.
E 6 2 0 1 (With yaw angular velocity sensor output
stopped.)
Symptom/State
1-5E
Correction
Inspect the lens block focus MR sensor (Pins qk, ql of CN5001 of
CD-458 board) when focusing is performed when the touch panel
is operated in the focus manual mode and the focus motor drive
signals (Pins 1, 2 of CN5001 of CD-458 board) when the focusing
is not performed.
Inspect the lens block zoom reset sensor (Pin qg of CN5001 of
CD-458 board) when zooming is performed when the zoom switch
is operated and the zoom motor drive signals (Pins wf to wj of
CN5001 of CD-458 board) when zooming is not performed.
Inspect pitch angular velocity sensor (SE2702 of SE-139 board)
peripheral circuits.
Inspect yaw angular velocity sensor (SE2701 of SE-139 board)
peripheral circuits.
DCR-IP1/IP1E