Sensor Info And Set-Up - Assa Abloy Norton SafeZone 7100SZ Series Installation And Instruction Manual

®
SafeZone
Sensor Technical Specifications
DESCRIPTION
Frequency:
Suppl voltage: y
Mounting height:
Tilt angle:
Detection area:
Wide
Narrow
Minimum detection speed:
Power consumption:
Standard output relay:
Max contact voltage
Max contact current
Max s itching po e w w r
Hold time:
Temperature range:
Dimensions:
Weight:
Material:
Safety Precautions
• Shut off all power going to the header before attempting any wiring procedures.
• Maintain a clean & safe environment when working in public areas.
•
Constantly be aware of pedestrian traffic around the door area.
•
Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by
the door.
• Always check placement of all wiring and components before po ering up
catch an w res and cause dama
•
Ensure compliance w
ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS
CAUTION
: In the event a unit needs to be opened, observe the following precautions.
• Ground yourself by touching a conductive surface of the door or other element connected to common earth

ground to discharge the static electricity present in your body.
•
Avoid walking around while replacing items inside the case, especially if you are on carpet or during
conditions of low temperature and low humidity.
 •
Handle the board by the edges only to avoid touching electronic components.

• Store a loose board in an anti-static bag.

Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
y i ge to equipment.
ith all applicable safet standards upon completion of installation.
Circuit board components are vulnerable to damage by electrostatic discharge
(ESD). ESD can cause immediate or subtle damage to sensitive electronic parts.
An electrostatic charge can build up on the human body and then discharge when
you touch a board. A discharge can be produced when walking across a carpet
and touching a board, for example. Before handling any board, make sure you
dissipate your body's charge.
SPECIFICATION
24.125 GHz
12 t 24 V DC: -10% / +30%:
Normal: 7'; Maximum: 10'-0"
0 to 90 vertical
-15 to +15 lateral
13ft (W) x 6.5ft (D)
6.5ft (W) x 8.2ft (D) (supplied as optional)
2 in/sec. (measured in axis)
< 2 W
60 VDC / 125 VAC
1 A (resistive)
30W (DC / 60V ) A (AC)
0.5 sec. to 9 sec. (adjustable)
-4°F to 131°F
4.75in (W) x 3.15in (H) x 2.0in (D)
0.5lbs
ABS
w
y
13
to ensure that moving door parts will not
80-9371-0085-020 (01-14)
ASSA ABLOY