Table of Contents
Advertisement
Bench test
Warning: Before you start any configuration, make sure only one unit is powered ON. Otherwise,
a different radio modem could reply to your requests! (All units share the same IP address and
are in Bridge mode when in factory settings.)
5.
IP address unknown
If you don't have the adapter or you have forgotten the password, you can reset the access para-
meters to defaults, see Section 4.2.6, "Reset button".
5.4. Basic setup
For the first functionality test we recommend that you use the setup wizard. The wizard will guide you
through basic functionality setup. Simply select Wizard in the web interface and proceed according to
the information on the screen. Repeat for all RipEX's in the test network.
If you want to test applications which require a more complex setup, see Chapter 7, Advanced Config-
uration. To setup the IP addresses you can use the examples in Section 2.3.3, "Router - Flexible,
Configuration examples" as your models, or the RipEX-App. notes, Address planing
5.5. Functional test
To test radio communication between the RipEX's you can use the Ping test, under Diagnostic/Ping
menu. Setting up and the output of this test are described in chapter Adv. Conf., Tools.
If the radio communication between RipEX's is functional, you can proceed with a test of communication
between the connected devices.
You can monitor the status of configuration using the diodes on the LED panel, see Section 4.3, "Indic-
ation LEDs".
1
http://www.racom.eu/eng/products/m/ripex/app/routing.html
84
RipEX Radio modem & Router – © RACOM s.r.o.
1
.
Advertisement
Table of Contents
