Gps - RACOM RipEX User Manual

Physical security = Off:
When button is depressed
Time [seconds]
0 - 5
5 - 15
15 - 18
30 - 33
Physical security = On:
When button is depressed
Time [seconds]
0 - 5
5 - 15
15 - 18
Default access settings:
ETH IP and Mask:
ETH Default GW:
ETH Speed:
DHCP:
ARP proxy & VLAN:
Firewall:
Hot Standby:
Routing table:
Management:
Username:
Password:
Note
To reset the RipEX only use the RESET button as described above or use the button in
RipEX's web configuration, see Adv. Conf., Maintenance. Never use a power cycling (dis-
connecting and reconnecting power supply) to reset it. While power cycle resets, or rather
reboots the RipEX, its software will not terminate correctly resulting in logs, statistics and
graphs not being saved properly.

4.2.7. GPS

RipEX can be equipped with an internal GPS, see Section 4.5,
"Model offerings". The GPS module is used for time synchronisation
of the NTP server inside RipEX. See Adv. Conf., Time for more. In
this case the front panel contains a SMA female 50 ohm connector
for connecting the GPS antenna.
• active or passive antenna
• 3.3 VDC supply
© RACOM s.r.o. – RipEX Radio modem & Router
Status LED action
Goes dark
Flashes Green
Flashes Green faster
Flashes Red faster
Status LED action
Goes dark
Flashes Green
Flashes Green faster
192.168.169.169/24
0.0.0.0
Auto
Off
Off
Off
Off
Deleted
Default (Web server=HTTP+HTTPS, CLI=SSH)
admin
admin
Action if button released
—
Device reboot
Default access settings, reboot
Factory Settings, reboot
Action if button released
—
Device reboot
Total purge, reboot
Fig. 4.14: GPS Connector SMA
Product
53