Indication Leds; Key To Leds - RACOM RipEX User Manual

Product

4.3. Indication LEDs

Fig. 4.15: Indication LEDs
Alarm – is "On" when any controlled item in Alarm management, (see Adv. Conf., Alarm man-
agement for more) is in alarm status (out of thresholds) and "SNMP Trap", "HW Alarm
Output" or "Detail graphs start" for any line in the Alarm configuration table are checked.
Emergency – Emergency status is an undefined RipEX status either because of a SW or HW problem
when RipEX does not function properly. Maintenance web page is mostly accessible
even in Emergency status. If the problem cannot be eliminated after a power cycle, send
the unit to RACOM for repair.
54
Tab. 4.5: Key to LEDs
Color
Green
Dark
Green flashes slowly
STATUS
Green flashes quickly
Red flashes quickly
Red
Green
blinks with a period of 1 sec
TX
Red
Green
RX
Yellow
Green
COM2
Yellow
Green
COM1
Yellow
Yellow ON
Yellow OFF
ETH
Green ON
Green flashes
Green
PWR Blinks with a period of 1 sec
Flashes once per 3 sec
Description
The RipEX OS (Linux) is running
successfully
Reset button has been pressed
reset after five-seconds pressing
the Reset button
default access after 15-seconds
pressing the Reset button
Emergency
Alarm
GPS module synchronized,
for RipEX-xxxG model only
transmitting to radio channel
receiver is synchronised to a
packet
there is a signal stronger than
−80 dBm on Radio channel
data receiving
data transmitting
data receiving
data transmitting
100 Mb/s speed
10 Mb/s speed
connected
Ethernet data
powered successfully
Save mode
Sleep mode
RipEX Radio modem & Router – © RACOM s.r.o.