Model Offerings; Ordering Code (Part No's) - RACOM RipEX User Manual

4.5. Model offerings

RipEX radio modem has been designed to have minimum possible number of hardware variants. Dif-
ferent HW models are determined by frequency, internal GPS and separate connectors for RX and TX
antennas.
Upgrade of functionality does not result in on-site hardware changes – it is done by activating software
feature keys (see chapter RipEX in detail and Adv. Config., Maintenance).

4.5.1. Ordering code (Part No's)

Trade name: RipEX
Type (according to bands): RipEX-160, RipEX-200, RipEX-300, RipEX-400, RipEX-900.
Code (according to the tuned frequency and specific HW models): e.g. RipEX-368, RipEX-432DG etc.
XXX – base frequency
Code Tuning freq. range
RipEX-135 135–154 MHz
RipEX-154 154–174 MHz
RipEX-215 215–240 MHz
RipEX-300 300–320 MHz
RipEX-320 320–340 MHz
RipEX-340 340–360 MHz
RipEX-368 368–400 MHz
RipEX-400 400–432 MHz
RipEX-432 432–470 MHz
RipEX-470 470–512 MHz
RipEX-928 928–960 MHz
yyy – HW models
empty – basic model
D – separate connectors for RX and TX antennas (Part No. RipEX-HW-DUAL)
G – internal GPS module (Part No. RipEX-HW-GPS)
S – Up to 50 kHz channel spacing (Part No. RipEX-HW-50kHz). "S" is used, because units with older
version radio boards (lower than 1.1.90.0 or 1.2.50.0.) don't support 50 kHz channel spacing.
P - Ingress Protection level IP51 - see Section 6.1.4, "IP51 mounting" for IP51 mounting details
Code examples:
RipEX-368 = RipEX for frequencies from 368 to 400 MHz
RipEX-400G = RipEX for frequencies from 400 to 432 MHz, with GPS module
RipEX-432DG = RipEX for frequencies from 432 to 470 MHz, with separate Rx and Tx antenna con-
nectors, with GPS module
RipEX-154S = RipEX for frequencies from 154 to 174 MHz, together with standard 6.25, 12.5, 25
kHz also 50 kHz channel spacing supported
SW feature keys
ROUTER – enables Operating mode Router. If not activated, only Bridge mode is available
(Part No. RipEX-SW-ROUTER)
© RACOM s.r.o. – RipEX Radio modem & Router
Product
69