Cisco ASR 902U Hardware Installation Manual page 55

Preparing for Installation
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
Warning
the network interface. Statement 1037
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning. Statement 1038
To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of 149°F (65°C). Statement 1047
The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
Warning
IMPORTANT SAFETY INSTRUCTIONS: This warning symbol means danger. You are in a situation
Warning
that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with
electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement
number provided at the end of each warning to locate its translation in the translated safety warnings that
accompanied this device. Statement 1071
Warning No user-serviceable parts inside. Do not open. Statement 1073
This is a Class A Device and is registered for EMC requirements for industrial use. The seller or buyer
Warning
should be aware of this. If this type was sold or purchased by mistake, it should be replaced with a
residential-use type. Statement 294
Warning This is a class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures. Statement 340
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
Standard Warning Statements
41