Set The Feed Angle - Pitney Bowes ADDRESSRIGHT DA750 Operator's Manual

3 • DA700/DA750 Features and Adjustments
Setting
Up A Job
(continued)
3-12

3. Set the Feed Angle

The height of the wireframe input stacker depends on the
type of material you're running:
• Heavy material—adjust to a low angle
• Standard material—adjust to the center (45 degree
angle)
• Light material—adjust to a high angle
To make the adjustment:
1. Unlock the knob on the wireframe slide by turning
counter clockwise.
2. Move the wireframe up or down as required by
sliding the retaining knob.
3. Turn the lock knob clockwise to secure the
wireframe.
NOTE: Center line of the knob aligns with
relative number of the scale. Refer to the
scale on following page.
Lock
Scale
SV61027 Rev. D