Specifying The Filtering Mode On A Split Screen; Table 1-3 Description Of The Display Commands That Can Use Regular Expressions - Huawei S9300 Configuration Manual

1 Displaying the Device Status
l
l
Table 1-3
refer to the Quidway S9300 Terabit Routing Switch - Command Reference.

Table 1-3 Description of the display commands that can use regular expressions

Command
display arp [ dynamic | static ] [ | { begin |
exclude | include } regular-expression ]
display current-configuration [ | { begin |
exclude | include } regular-expression ]
display current-configuration
configuration [ configuration-type ] [ |
{ begin | exclude | include } regular-
expression ]
display current-configuration interface
[ interface-type [ interface-number ] ] [ |
{ begin | exclude | include } regular-
expression ]
display interface [ interface-type [ interface-
number ] ] [ | { begin | exclude | include }
regular-expression ]
display logbuffer [ level severity | size size ]
*
expression ]

1.3.2 Specifying the Filtering Mode on a Split Screen

If a lot of information is displayed on a split screen after the display command is run, you can
enter the following escape characters and the corresponding character strings when "---- More
----" is prompted.
l
l
l
For example, when running the display command to check the current configuration, you can
display all the lines that match the keyword interface.
<Quidway> display current-configuration
#
1-4
exclude: displays all lines without the character string that matches the specified regular-
expression.
include: displays all lines with the character string that matches the specified regular-
expression.
lists the display commands using regular expressions. For details on the commands,
[ | [ exclude | include ] regular-
"/": functions the same as begin.
"-": functions the same as exclude.
"+": functions the same as include.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Description
The display arp command is used to display
the Address Resolution Protocol (ARP)
mapping table.
The display current-configuration
command is used to display currently valid
parameters.
The display interface command is used to
display the running status, basic
configuration, and statistics on packet
transmission on an interface.
The display logbuffer command is used to
display information recorded in the log
buffer.
Issue 02 (2009-08-06)