Set; 8�1 Activate Adjustment Mode; 8�2 Determine The Enable Zone - IFM Electronic GM705S Original Operating Instructions

8 Set-up
8.1 Activate adjustment mode
For easy and reliable installation the sensor can be put in the adjustment mode�
0
> 5 s
Signal
Power
close range

enable zone

8.2 Determine the enable zone
If the sensor is in the adjustment mode, the enable zone of the sensor can be
determined by moving the damping element�
0
Signal
Power
close range

enable zone

10
45
45
Signal Signal
Power Power
This is done by placing a metallic
object directly in front of the sensing
face of the fail-safe sensor (close
range)�
After approx� 5 s the yellow LED
starts to flash: The adjustment mode
mm
is active�
As long as this mode is active the
output stages remain in the safe
state�
As soon as damping is carried out
in the enable zone, the yellow LED
goes out�
If the target is in the close range or in
the immediate vicinity of the enable
zone, the LED starts to flash again�
mm