View Event Logs/View Fatal Logs; View Software/Hardware Version Information; View Lockout Parameters; Encoder Lockout - Lincoln Electric POWER FEED 25M Operator's Manual

®
POWER FEED 25M & 25M ALUMINUM
Parameter
P.101 View Event Logs
Used for viewing all the system event logs. Press the Right Button to enter the option. Rotate Control Knob to
select the desired event log to read. Press the Right Button again to enter the selected log. Rotating the Control
Knob will scroll through the event log, displaying the log index number, event code and some other data. Press
the Left Button to back out to select another log. Press the Left Button again to exit this option.
P.102 View Fatal Logs
Used for viewing all the system fatal logs. Press the Right Button to enter the option. Rotate Control Knob to select
the desired fatal log to read. Press the Right Button again to enter that log. Rotating the Control Knob will scroll
through the log, displaying the log index number and fatal code. Press the Left Button to back out to select
another log. Press the Left Button again to exit this option.
P.103 View Software Version Information
Used for viewing the software versions for each board in the system. Press the Right Button to enter the option.
Rotate Control Knob to select the desired board to read. Press the Right Button again to read the firmware version.
Press the Left Button to back out to select another board. Rotate the Control Knob to select another board, or
press the Left Button to exit this option.
P.104 View Hardware Version Information
Used for viewing the hardware version for each board in the system. Press the Right Button to enter the option.
Rotate Control Knob to select the desired board to read. Press the Right Button again to read the hardware
version. Press the Left Button to back out to select another board. Press the Left Button again to exit this option.
P.105 View Welding Software Information
Used for viewing the Weld Set in the Power Source. Press the Right Button to read the Weld Set version. Press the
Left Button to back out and exit this option.
P.106 View Ethernet IP Address
Used for viewing the IP address of Ethernet compatible equipment. Press the Right Button to read the IP Address.
Press the Left Button to back out and exit this option. The IP address cannot be changed using this option.
P.107 View Power Source Protocol
Used for viewing the type of power source the feeder is connected to. Press the Right Button to identify the power
source as either LincNet or ArcLink. Press the Left Button to back out and exit this option.
P.350 User Interface Group Selection
Used to differentiate multiple PF25M feeders connected to the same power source. Each independent feeder must
have a unique selection in order to resolve error 18 problems.
P.500

View Lockout Parameters

Originally used to prevent inadvertent changes of secure setup parameters, P.500 was previously used as a
gateway to these parameters. Presently, this option does not exist in any setup menu.
P.501

Encoder Lockout

Locks one or both of the upper knobs (encoders), preventing the operator from changing wire feed speed, amps,
volts or trim. The function of each upper knob depends on the selected weld mode. When a constant current weld
mode is selected (e.g. Stick, TIG, Gouge), the upper right knob will always function as an on/off switch. This
parameter can only be accessed using Power Wave Manager software.
USER DEFINED PARAMETERS
Definition
B-28
OPERATION