Reset Consumable Weight; Push-Pull Gun Knob Behavior; Remote Control Type - Lincoln Electric POWER FEED 25M Operator's Manual

®
POWER FEED 25M & 25M ALUMINUM
Parameter
P.14

Reset Consumable Weight

Use this option to reset the initial weight of the consumable package. Press the Right Button to reset the consumable weight.
This option will only appear with systems using Production Monitoring.
P.16

Push-Pull Gun Knob Behavior

This option determines how the potentiometer on the Push/Pull torch will behave.
• Gun Pot Enabled = The welding wire feed speed is always controlled by the potentiometer on the push-pull gun (default).
The left front panel knob is only used to adjust Start and Crater wire feed speed.
• Gun Pot Disabled = The wire feed speed is always controlled by the left front panel knob. This setting is useful when the
operator wishes to have wire feed speed settings recalled from memories and not have the potentiometer "overwrite" the
setting.
• Gun Pot Proc A = When in procedure A, the welding wire feed speed is controlled by the potentiometer on the push-pull gun.
When in procedure B, the welding wire feed speed is controlled by the left front panel knob. This setting allows a fixed wire
feed speed to be selected in procedure B and not have the potentiometer "overwrite" the setting when the procedure
changes.
P.17

Remote Control Type

This setup parameter was previously named "Spool/Push-Pull"
This option selects the type of analog remote control being used. Digital remote control devices (those with a digital display)
are configured automatically. Not all P.17 selections will be available on all machines. When P.17 is used to configure the
remote control to function in a specific process, the remote will be ignored in other processes. For example, if P.17 = TIG Amp
Control, the remote control will only function when TIG welding - the remote will be ignored in other processes (MIG, stick and
gouge). If P.17 is set to Spool Gun or Push-Pull Gun then set to All Mode Remote, the machine will remember prior value of
P.17 and will operate a Spool Gun or Push-Pull Gun, depending on the prior value of P.17.
Spool Gun = Use this setting while MIG welding with a spool gun that uses a potentiometer used for wire feed speed control
(this setting is backward compatible with "P.17 Gun Selection" = Standard/Spool).
Push-Pull Gun = Use this setting wile MIG welding with a push-pull gun that uses a potentiometer for wire feed speed control
(this setting is backward compatible with "P.17 Gun Selection" = PushPull).
TIG Amp Control = Use this setting while TIG welding with a foot or hand current control device (Amptrol). While TIG welding,
the upper left knob on the User Interface sets the maximum current obtained when the TIG amp control is at its maximum
setting.
Stick/Gouge Rem. = Use this setting while stick welding or gouging with a remote output control device. While stick welding,
the upper left knob on the User Interface sets the maximum current obtained when the stick remote is at it's maximum setting.
While gouging, the upper left knob is disabled and the gouging current is set on the remote control.
All Mode Remote = This setting allows the remote control to function in all weld modes which is how most machines with 6-
pin and 7-pin remote control connections operate. This setting was provided so that customers with a mix of Lincoln Electric
equipment can have consistent remote control behavior across all of their equipment. (N. American default)
Joystick MIG Gun = Use this setting while MIG welding with a push MIG gun with a joystick control. Stick, TIG and gouge
welding currents are set at the User Interface. (European default)
USER DEFINED PARAMETERS
Definition
B-25
OPERATION