Case Front Controls - Lincoln Electric POWER FEED 25M Operator's Manual

®
POWER FEED 25M & 25M ALUMINUM

CASE FRONT CONTROLS

(SEE FIGURE B.1)
1. Left DISPLAY window
Shows WIRE FEED SPEED or AMPERAGE.
2. Left KNOB
Adjusts values in left display.
3. Status LED
Illuminates a steady green when communicating to the power
source properly.
4. Main display
Shows detailed welding and diagnostic information.
5. Left Button
Changes the Main display to show the Weld Mode or UltimArc.
6. Procedure Button
Selects A or B procedure, or gun control.
7. 2-Step/4-Step Button
Toggles between 2-step and 4-step trigger operation.
8. 5-pin connector
Trigger connector for a push-only gun.
9. ON/OFF switch
Controls power to the POWER FEED
10. 3 Amp Circuit Breaker
Protects the 12-pin accessories
11. 12-pin connector
Connection for push-pull guns, remotes
12. Cover
Covers location for optional water cooling line.
13. Right Display window
Shows VOLTAGE or TRIM.
14. Right Knob
Adjusts values in the right display.
15. Thermal
Lights when the drive overheats.
®
25M.
B-2
16. Set-Up
Lights when feeder is set-up.
17. Right Button
Changes the Main display to show Start Options or End
Options.
18. Set Knob
Changes the value on the Main display.
19. Memories Buttons
For selection of common procedures.
FIGURE B.1
1
2
3
4
5
6
9
10
11
OPERATION
13
14
15
16
17
18
19