Appendix; Glossary - Siemens SIMATRIX NEO V2 Configuration Manual

Appendix

11 Appendix
11.1

Glossary

Alarm image switching
Alarm image sequence
Alarm sequence
Autoreset
Image sequence
Dome cameras
CCDA
CCTV
External detection group
Group switching
IVM-NT
LMS
Manual reset
Pelco D
Serial switching, stepped
switching
transfer switching
SCU protocol
SISTORE NT
Sivis Minidome
Stack alarm
Stack reset
SysLink
TELEMAT MD/MTD
Time-lapse operation
46
Siemens AB
Security Products
An alarm image appears on the monitor until it is acknowledged
All as yet acknowledged alarm images are shown repeatedly in sequence on a monitor
See alarm image sequence
The alarm image disappears from the monitor, as soon as the alarm signal resets. See also manual
reset and stack reset
Images from several cameras can be switched to a monitor in sequence. The image sequence can
be started or stopped by a key on the keyboard. Alternatively, the system can be configured to
display preset camera images upon start-up.
Ceiling-mounted, rapid-response, remote control camera with a lens drive system. Housed in a
glass dome.
Siemens dome cameras
Closed Circuit Television, independent television system in a delimited area
A key on the keyboard is used to switch the images from a camera group to a group of monitors.
Integrated Video Management System
Location planning system
As opposed to autoreset. The alarm image remains on display when the alarm signal resets. Alarm
events that have already been displayed are overwritten without being stored in memory. See also
autoreset and stack reset
3rd party supply dome camera
When several alarm images are switched simultaneously, the most recent alarm image is displayed
on all monitors in turn. This only applies to monitors that have been configured for alarm image
switching.
The most recent alarm image is always displayed on the primary monitor (master monitor) in the
monitor group. When several alarm images are displayed simultaneously, the less recent images
are transferred to the other monitors.
Protocol for controlling telemetry devices
Image storage system
Siemens dome cameras
New alarm images overwrite old alarm images (manual and autoreset)
As manual reset, but the alarm events are saved to memory before being overwritten by new alarm
events. See also autoreset and manual reset
Serial system bus. Allows connection of the extension bay and alarm box
Video sensor that recognises motion in the camera image
Long-term recording of individual images