Programming Signals From Other Remote Controls (Learning Mode) - Pioneer Elite VSX-47TX Operating Instructions Manual

Remote Control of Other Components

Programming Signals from Other Remote Controls (LEARNING Mode)

If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this procedure to program in signals from the remote control(s) of your other component(s). These
steps can also be used to add further operations to the remote control that were successfully set with the
stored settings (see p.62-63).
• To exit from the remote control setup mode at any time, press REMOTE SETUP.
memo
• You can also program the 5˜∞˜2˜3 and ENTER buttons with the LEARNING mode.
• The TUNER button cannot be assigned.
• The display will disappear after one minute or so if no new commands are entered. Press any button
to 'wake up' the remote and continue the process.
S0URCE
DVD/LD
3
VCR1/
DVR
CD
DIMMER
1
VIDEO SEL
5
TONE
9
SYSTEM SETUP
MENU
2
TUNER EDIT
STATUS
GUIDE
MPX
¶
TUNING
1
STATION
4
CHANNEL
TV VOL
THX
ADVANCED
CINEMA
ACOUSTIC
CAL
AV PRE-PROGRAMMED AND LEARNING
64
SETUP
TV SYSTEM RECEIVER
OFF
TV SAT TV CONT
MULTI CONTROL
MULTI
VCR2 VIDEO
OPERATION
CD-R/
TUNER RECEIVER
TAPE1
INPUT ATT LOUDNESS SPEAKER A/B
2 3 4
SIGNAL SEL TAPE 2 EFFECT/CH SELL
6 7 8
– +
+
BASS/TREBLE
10 DISC
0
ENTER
DIRECT ACCESS DISP MODE
1
REMOTE SETUP
ENTER
EXIT
RETURN
DTV ON/OFF
8
EXTRA MENU
– +
BAND TUNING
3 ¡
– +
DTV MENU CLASS STATION
7 ¢
– +
CHANNEL
TV INPUT INPUT
TV CONTROL
MIDNIGHT VOLUME
TV CH
DIGITAL
NR
STEREO
STANDARD MUTE
/DIRECT
SURROUND
LISTENING
ADVANCED MODE
CONCERT
(DVD-A/SACD)
MULTI CH LISTENING
LIGHT
INPUT CH SELECT
Î
REMOTE CONTROL UNIT
AXD7290
1 Press the REMOTE SETUP button for
three seconds.
The REMOTE SETUP menu appears on the remote
display.
2 Use the 5∞ buttons to select
LEARNING and press ENTER.
SELECT FUNCTION blinks on the remote control.
3 Press the MULTI CONTROL button
for the component you want to
control.
For example DVD/LD
SELECT KEY flashes in the display.
4 Choose the command you want to
teach the remote control and press
the corresponding button. The word
LEARN will blink in the remote
control display.
For example, choose the 3 (play) button to program
this remote control to play your DVD player.
• The TV POWER, TV FUNC, TV CH +/– and VOL +/–
buttons are only available for learning when
programming TV CONT button.