Pioneer Elite VSX-47TX Operating Instructions Manual page 63

VIDEO SEL SIGNAL SEL TAPE 2 EFFECT/CH SELL
5 6 7
– +
TONE BASS/TREBLE 10
9 0
DIRECT ACCESS DISP MODE
SYSTEM SETUP REMOTE SETUP
MENU
6-9
TUNER EDIT
ENTER
STATUS
GUIDE
MPX
DTV ON/OFF
¶ 8
EXTRA MENU
–
TUNING BAND TUNING
1 3
–
STATION DTV MENU CLASS STATION
4 7
–
CHANNEL CHANNEL
6 Point the remote control at the
8
+
DISC
ENTER
EXIT
RETURN
+
¡
+
¢
+
7 Press ENTER. The preset code has
8 Repeat the process from step 2 for
9 Select EXIT and press ENTER.
Remote Control of Other Components
component you want set and press
ENTER.
OK? will appear in the remote control display.
If the component you are trying to control turns on/off
you have set it correctly. Use the 5∞ buttons to select
YES and go on to step 7.
If the component you are trying to control does not
turn on/off the correct preset code has not been
selected. In this case, use the 5∞ buttons to select
NO, press ENTER and go back to step 5. Try another
preset code for that maker. (If the component you are
trying to setup doesn't have a standby/on mode it
won't turn on even if the correct preset code is
entered. In this case select YES and go on to step 7.)
If you can't seem to get the component you are trying
to set to turn on or off you can still set up your remote
control by using the LEARNING mode (on the next
page).
been entered.
COMPLETE will appear in the display.
Naturally it's easiest and most logical to assign the
button that has the same name as the component you
are setting up (for example, choose the DVD/LD button
for your DVD player).
You may find you have components which do not
correspond to the name on any MULTI CONTROL
button (for example a cable TV tuner) or you have two
components where only one button is provided (for
example, CD-R/TAPE 1). In this case, use step 3 to
assign any available MULTI CONTROL button to the
component you want to remote control.
For example, you may have both a CD-R and a tape
deck in your system but only one video deck. It would
make sense to assign the CD-R/TAPE 1 MULTI
CONTROL button to the CD-R and the VCR 2 MULTI
CONTROL button to your tape deck. To do this choose
VCR 2 in step 3 when you want to set up the tape
deck. Then choose TAPE in step 4 and proceed as
above. The only practical difference in this method is
that you have to remember the VCR 2 MULTI CON-
TROL button is actually your tape deck.
In this case, you would need to hook up your tape
deck to the input jacks marked VCR 2 on the back of
the receiver.
This method should help you customize the remote
control for your system and let you control all of your
components with the remote control for the VSX-47TX.
all of your components.
63