Programming Signals From Other Remote Controls (Learning Mode) - Pioneer Elite VSX-43TX Operating Instructions Manual

Remote Control of Other Components

Programming Signals from Other Remote Controls (LEARNING Mode)

If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this procedure to program in signals from the remote control(s) of your other component(s). These
steps can also be used to add further operations to the remote control that were successfully set with the
stored settings (see page 59).
• To exit from the remote control setup mode at any time, press REMOTE SETUP.
memo
• You can also program the 5˜∞˜2˜3 and ENTER buttons with the LEARNING mode.
• The TUNER button cannot be assigned.
• Some commands cannot be learned.
RECEIVER
MULTI SYSTEM
OPERATION
MULTI CONTROL
2
DVD/LD VCR/DVR
TV / SAT
C D
VCR 2 TUNER
ACOUSTIC
MOVIE MUSIC
SURROUND
SB CH
MODE
MODE
STEREO/
ENTER
DIRECT MIDNIGHT
MASTER
VOLUME
MENU TUNER EDIT
TUNE
SYSTEM
SETUP
ST
ENTER
AUDIO
TUNE
CHANNEL DTV ON/OFF BAND
D.ACCESS
DIMMER LOUDNESS
SIGNAL SEL DNR BASS/TREBLE
VIDEO SEL HI-BIT
TV CONTROL
CHANNEL VOLUME
RECEIVER
60
LED
SOURCE
OFF
TV CONT
RECEIVER
EQ INPUT
MULTI CH
INPUT
MUTE
Buttons
TOP MENU
that are
GUIDE
able to
3
ST
learn new
commands
RETURN
CHANNEL
1
MPX CLASS
TONE EFFECT/CH SEL
ENTER
DISC
10
SUB TITLE
1
REMOTE
SETUP
1 While holding down the REMOTE
SETUP button press
learning setup mode.
The LED begins to blink.
To cancel the learning setup mode press REMOTE SET
UP.
2 Press the MULTI CONTROL button
for the component you want to
control.
The LED lights continously.
3 Press the button to be programmed.
For example DVD/LD
The LED blinks rapidly.
• The TV , TV INPUT SELECT, TV CHANNEL +/–
and TV VOLUME +/– buttons are only available for
learning when programming TV CONTROL
operations.
4 Point the remote controls at each
other and press the button on the
other remote control for the
operation you wish to program .
1 Point the remote controls toward each other.
2 Press the button on the other remote control
corresponding to the operation you wish to
program.
The LED will turn off and then light again.
To program additional operations for the current
component, repeat steps 3 and 4.
To program operations for another component,
repeat steps 2 through 4.
5 Press the REMOTE SETUP button to
exit the learning setup mode.
The remote control and receiver return to their
previous operation modes.
to select the
2-8 inches