Dual Mono Setting And Playback; Input Attenuator; Tape 2 Monitor - Pioneer Elite VSX-47TX Operating Instructions Manual

Basic Operation

DUAL MONO setting and playback

The dual mono setting can only be used when listening to Dolby Digital or homemade discs that have dual mono
software encoded in them. Dual mono software usually is used to put two different mono recordings with one
soundtrack on one DVD. With this setting you can choose which channel in the dual mono setting you want to
listen to. Remember this setting is only applicable if you are using Dolby Digital software with dual mono and
want to isolate one of the channels therein.
TONE
ACOUSTIC
CAL. MIDNIGHT TONE BASS/TEREBLE
PHONES SP SYSTEM SIGNAL VIDEO
A/B SELECT SELECT
• The default setting is DUAL ch1.
memo
• You can only use this function with
Dolby Digital sources that have this
function

Input Attenuator

The input attenuator lowers the input level of an analog signal when it is too strong, causing distortion in the
sound.
S0URCE
DVD/LD
MULTI CONTROL
VCR1/
DVR
CD
2
DIMMER
1
VIDEO SEL
5
TONE
9

Tape 2 Monitor

If you connect a cassette deck with a record monitor function (a three-head tape deck) to the TAPE 2
MONITOR jacks, you can listen to the sound of an analog recording as it's being recorded.
S0URCE
DVD/LD
MULTI CONTROL
VCR1/
DVR
CD
DIMMER
1
VIDEO SEL
5
54
TONE
9
SYSTEM SETUP
TUNER MULTI ROOM & SOURCE
LISTENING
DIGITAL NR CLASS STATION CH SELECT CONTROL ON/OFF
TAPE2
MULTI CH
MONITOR INPUT
(DVD-A/SACD)
SETUP
DIGITAL IN
MIC S-VIDEO VIDEO L AUDIO R
VIDEO INPUT
1
SETUP
TV SYSTEM RECEIVER
OFF
TV SAT TV CONT
MULTI
VCR2 VIDEO
OPERATION
1
CD-R/
TUNER RECEIVER
TAPE1
INPUT ATT LOUDNESS SPEAKER A/B
2 3 4
SIGNAL SEL TAPE 2 EFFECT/CH SELL
6 7 8
– +
+
BASS/TREBLE 10 DISC
0
ENTER
D RECT ACCESS D SP MODE
SETUP
TV SYSTEM RECEIVER
OFF
TV SAT TV CONT
MULTI
VCR2 VIDEO
OPERATION
1
CD-R/
TUNER RECEIVER
TAPE1
INPUT ATT LOUDNESS SPEAKER A/B
2 3 4
2
SIGNAL SEL TAPE 2 EFFECT/CH SELL
6 7 8
– +
+
BASS/TREBLE
10 DISC
0
ENTER
DIRECT ACCESS DISP MODE
REMOTE SETUP
1 Press the LISTENING CH SELECT
button for more than five seconds to
put the receiver in DUAL MONO
mode.
Hold down the LISTENING CH SELECT button to cycle
through the different DUAL MONO settings. When you
find the one you want release the button. The L (ch1)
and R (ch2) indicators in the display light to indicate the
playback channel.
DUAL : ch1
DUAL: ch1/ch2
The different settings are: DUAL ch1, where you only
hear channel 1; DUAL ch2, where you only hear channel
2; and DUAL ch1/ch2, where you hear both channels,
but independently from different speakers.
1 Press RECEIVER.
2 Use the INPUT ATT button on the
remote control.
1 Press RECEIVER.
2 Use the TAPE 2 MONITOR button on
the remote control to listen to the
component hooked up to the TAPE 2
MONITOR jacks.
DUAL : ch2