Assigning The Component Video Inputs - Pioneer Elite VSX-47TX Operating Instructions Manual

Assigning the Component Video Inputs

This receiver has three component video inputs. By default they act as video inputs for the DVD/LD, TV
and SAT functions, but you can reassign them if you want to use them as video inputs for other receiver
functions. For example, if you have a DVD recorder connected to the VCR1/DVR jacks and want to use its
component video output, and you're not using the COMPONENT VIDEO IN 3 jacks on this receiver, you
can reassign the input from SAT to VCR1.
See pages 16–19 for more on connecting equipment using component video cords.
S0URCE TV SYSTEM RECEIVER
OFF
DVD/LD TV SAT
MULTI CONTROL
VCR1/
VCR2 VIDEO
DVR
CD-R/
CD TUNER
TAPE1
DIMMER INPUT ATT LOUDNESS
1 2
VIDEO SEL SIGNAL SEL TAPE 2
5 6
TONE BASS/TREBLE
9 0
DIRECT ACCESS DISP MODE
2
SYSTEM SETUP
MENU
TUNER EDIT
ENTER
STATUS
GUIDE
MPX
DTV ON/OFF
¶ 8
–
TUNING BAND
3
System Setup
[ Auto Surround Setup ]
[1. Input Assign
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
4
1.Input Assign
[ 1.Digital-In Select ]
[ 2.C'nent Video
[Return]
5
1.2. C' nent Video In
C' nent-In1
C' nent-In2
C' nent-In3
[Return]
6
1.2. C' nent Video In
C' nent-In1
C' nent-In2
C' nent-In3
[Return]
SETUP
TV CONT
MULTI
OPERATION
1
RECEIVER
SPEAKER A/B
3 4
EFFECT/CH SELL
7 8
– + +
10 DISC
ENTER
REMOTE SETUP
3-8
EXIT
RETURN
EXTRA MENU
+
TUNING
]
In]
[DVD/LD ]
[ TV ]
[ SAT ]
[ DVD/LD ]
[ TV ]
[ VCR1 ]
1 Turn on the receiver and your TV,
press RECEIVER on the remote
control.
2 Press the SYSTEM SETUP button.
3 Looking at the on-screen display on
your TV, use the 5∞ buttons to
select INPUT ASSIGN. Press the
ENTER button.
4 Use the 5∞ buttons to select
C'NENT VIDEO IN then press ENTER.
5 Use the 5∞ buttons to select the
component video input you want to
reassign.
In the example above, we would select C'NENT-IN 3.
6 Use the 2 3 buttons to assign a
receiver function.
Choose between DVD/LD, TV, SAT, VCR1 and VCR2.
In the example above, we would select VCR1
7 When you're finished use the 5∞
buttons to select RETURN and press
ENTER.
You will leave the "Assigning the Component Video
Inputs" mode.
8 Use the 5∞ buttons to select
RETURN and press ENTER, again.
Then, use the 5∞ buttons to select
EXIT and press ENTER.
If you connect any source component to the
memo
receiver using a component video input, you
should also have your TV connected to this
receiver's component video output.
Advanced Setup
89