Multi Channel In Setting; Multi Channel In Setting Using The Main Unit - Pioneer Elite VSX-37TX Operating Instructions Manual

Initial Set Up

Multi Channel In Setting

If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS,
that is coming out of the decoder at full volume, or set to ADJUST, which means the levels can be reduced in
volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps 1-3 in "Setting
Up for Surround Sound" (p.29) first.
Î
USE
S0URCE
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1
MULTI CONTROL
MD/
CD TUNER
TAPE1
CLASS MPX BAND
¶ 7 3
- -
+
TUNING STATION
1 ¡ 4
-
DTV ON/OFF DTV MENU CHANNEL
1 2
4 5
7 8
GUIDE
0
+10
+
TV
TV VOL TV CONTROL
–
TV FUNC
REMOTE SETUP
INPUT
MENU
ATT
SYSTEM SETUP
EFFECT/ +
CH SEL
ENTER
DIGITAL
–
NR
MULTI CH
MIDNIGHT DSP
INPUT
/ DTS
LIGHT THX ADVANCED
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT

Multi Channel In Setting Using the Main Unit

You can also use the main unit to change the sound level of the MULTI CH IN. Follow the step below.
STANDBY/ON
STANDBY/ON
STANDBY
THX CINEMA
S-VIDEO
PHONES
40
1 Use the 5¥∞ buttons to select MULTI
SETUP
RECEIVER
VCR2
TVCONT
DIRECT ACCESS
8
+
¢
+
3
6
9
EXIT
ENTER
DISC
+
VOLUME
–
MUTE
2 Use the 2¥3 buttons to select the setting
FUNCTION
1-3
SIGNAL
SELECT
STEREO/
DIRECT
STANDARD
3 Use the 5¥∞ buttons to select EXIT.
MULTI CH INPUT
N∫m¿≤≥ım
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
MULTI-ROOM
DSP STEREO/
&SOURCE
MODE DIRECT
/DTS
CONTROL
ADVANCED STANDARD
MD/TAPE1/
VIDEO VCR 1/DVR VCR 2 DVD/LD TV/SAT CD CD-R TUNER PHONO
CHANNEL
MULTI CH DIGITAL SIGNAL FL
TONE SELECT LOUDNESS NR SELECT DIMMER CLASS BAND - TUNING +
VIDEO INPUT INPUT
VIDEO L AUDIO R
TUNER CONTROL
VIDEO TAPE 2
SPEAKERS - BASS + - TREBLE + SELCT MONITOR MPX MEMORY - STATION +
CHANNEL IN.
See "Setting Up for Surround Sound" on page 29 if you need
more information.
Press the ENTER button.
This information will be displayed on your TV.
Multi channel in
Select mode
[Channel Level]
[BYPASS]
[EXIT]
you want, BYPASS or ADJUST.
ADJUST
Use the ADJUST setting when you want to be able to control
each channel level individually.
BYPASS
This setting is good for getting the cleanest possible signal. In this
setting you won't be able to change each channel individually.
We recommend using BYPASS and the default setting is
BYPASS.
Press the ENTER button.
You wil return to the SYSTEM SETUP mode.
1 Put receiver in the STANDBY mode.
2 While holding down the MULTI CH
INPUT button press the
INPUT
SELECTOR
STANDBY/ON button.
MASTER
VOLUME
The setting will change depending on what state
MIN MAX
the receiver was previously in. For a few seconds
the display will show you which MULTI CH setting
you are now in.
memo
The default setting is BYPASS.