Pioneer Elite VSX-37TX Operating Instructions Manual page 79

MULTI-ROOM set up
After you have completed the necessary connections for MULTI-ROOM operation you need to set up the
receiver for such operation. Follow the instructions below. The page after this one explains how to use the
MULTI-ROOM function once it's been set up.
Î
USE
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
- +
DTV ON/OFF DTV MENU CHANNEL
1 2 3
4 5 6
7 8 9
GUIDE
0
ENTER
+10
+ +
TV
TV VOL TV CONTROL VOLUME
– –
TV FUNC
REMOTE SETUP
INPUT
MENU MUTE
ATT
SYSTEM SETUP
+
EFFECT/ FUNCTION
2,6 CH SEL
ENTER
DIGITAL SIGNAL
–
NR SELECT
MULTI CH STEREO/
MIDNIGHT DSP
INPUT
DIRECT
/ DTS
LIGHT THX ADVANCED STANDARD
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
CAUTION!
If the MULTI ROOM is set to FIXED
the volume on the main unit will be
set to maximum. Thus, when output,
it will be extremely loud. Please set
the master volume controls of the in-
tegrated amplifier in the sub room
very low at first and experiment to find
a suitable volume.
memo
Some IR RECEIVERS may not work
with this system, check with a Pioneer
representative to be sure.
1 Set the slide switch to SETUP.
1
SETUP
Also make sure that the TV is on and set to the receiver.
2 Press SYSTEM SETUP on the remote
control.
The REMOTE SETUP MENU appears on your TV screen. You
can escape from this screen at any time by pressing SYSTEM
SETUP again.
EXIT
Multi-Room
DISC
Volume Level
IR Receiver
[EXIT]
CAUTION : If the "FIXED"
position is chosen, the
volume will be loud.
3,4
5,6
3 Use the 5¥∞ buttons to select the MULTI-
ROOM set up mode and press ENTER.
4 Select the VOLUME LEVEL by using the
2¥3 buttons.
If you hook up a just a power amplifier in the sub room the
receiver will act as a pre-amp. In this case choose VARIABLE
for the VOLUME LEVEL setting. If you hook up a full integrated
amplifier in the sub room (such as another Pioneer VSX receiv-
er) choose FIXED for the VOLUME LEVEL setting.
5 Select the IR RECEIVER type with the 5¥∞
buttons and select the type by using the
2¥3 buttons.
If you have the Pioneer-made MR-100 select PIONEER. If you
have an IR RECEIVER from a different company, select
OTHERS.
6 Move to the EXIT setting and press ENTER
to exit MULTI-ROOM set up and return to
the SYSTEM SETUP MENU operations.
You can leave the MULTI ROOM set up mode any time by
pressing the SYSTEM SETUP button.
• When you're done setting up, remember to set the slide
switch back to USE.
Using Other Functions
[VARIABLE]
[PIONEER]
79