Installing The Receiver; Opening The Front Panel - Pioneer Elite VSX-37TX Operating Instructions Manual

Operating range of remote control unit
The area in which you can use the remote control to
operate the VSX-37TX/36TX is fairly large. To use,
point the remote control toward the remote sensor on
the front panel of this unit while within the range
shown right.
Remote control may not function properly if:
• There are obstacles between the remote control
and the remote sensor.
• Direct sunlight or fluorescent light is shining onto
the remote sensor.
• The receiver located near a device emitting infrared
rays.
• Operated simultaneously with another remote
control which uses infrared rays.

Installing the Receiver

Please note:
• Do not place objects directly on top of this unit. This would
prevent proper heat dispersal.
• When installing in a rack, shelf, etc., be sure to leave more
than 8 inches of space above the receiver.

Opening the Front Panel

To open the front panel push gently on the lower third of the panel
with your finger.
Before You Start
30
30
23 feet (7m)
8 inches (20 cm)
Receiver
11