Display - Pioneer Elite VSX-37TX Operating Instructions Manual

Display

All the display information is explained and/or referenced here.
1
2
SIGNAL
SELECT OVER
ANALOG SP
DIGITAL
AC-3RF
AUTO
AC-3DTS
L C
LS S RS
1 SIGNAL SELECT indicators
Light to indicate the input signal you selected.
ANALOG : Lights when analog signals are
assigned.
DIGITAL: Lights when digital audio signals are
selected.
AC-3 RF(VSX-37TX only): Lights when AC-3 RF
signals are assigned.
AUTO: Lights when the receiver is set to select
the input signal automatically.
2 Program Format indicators
AC-3: Lights when a source with Dolby Digital
signals is played.
DTS: Lights when a source with DTS audio
signals is played.
For Dolby Digital or DTS sources: These
indicators change according to which channels are
active in the source. When all three LS (left
surround), S (surround) and RS (right surround)
light at the same time it means a source with a
Surround EX or DTS ES flag is being used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low Frequency Effects channel.
3 Analog level indicators
OVER – When the source signal is analog, this
lights if the signal is in danger of distorting. Press
INPUT ATT on the remote control to lower the
signal level.
ATT – Lights when INPUT ATT is used to reduce
the level of the analog source signal.
4 Speaker indicators
Light to indicate the current speaker system, A
and/or B.
5 LOUDNESS indicator (See p.49)
Lights when the LOUDNESS mode is on.
6 H.P (headphones)
Lights when headphones are connected to the
PHONES jack (speakers systems A and B both
turn off automatically).
3 4 5 6
7 8
ATT LOUDNESS MIDNIGHT DSP
H.P
AB
MONO STEREO
TUNED AMFM
LFE
R
15
11
9 10
STEREO
PRO LOGIC
DIGITAL
14
7 MIDNIGHT indicator (See p.49)
Lights when the MIDNIGHT LISTENING mode
is on.
8 DSP indicator (See p.41-45, 47)
Light when a DSP or Advanced Theater mode
is selected.
9 STEREO indicator
Lights when a STEREO mode is selected.
10 Radio Frequency/Function indicator
Displays the function or the frequency of the
current radio station.
11 2/dts mode indicators
2
DIGITAL : When the
receiver is on, this indicator lights to indicate
playback of a Dolby Digital signal. However,
PRO LOGIC lights during 2 channel playback of
Dolby Digital.
2
PRO LOGIC: When the
receiver is on, this indicator lights during 2 channel
playback.
2
DTS : When the
on, this indicator lights to indicate playback of a
DTS signal.
THX: Lights when the HOME THX CINEMA mode
is selected.
12 MASTER VOLUME indication
Displays current volume level.
13 TAPE 2 indicator
Lights when the TAPE 2 monitor is on.
14 Character display
Shows current mode, status, etc.
15 Tuner indicators
MONO: Lights when the tuner is set to receive
FM broadcasts and when selected MPX mode.
STEREO: Lights when a FM stereo broadcast is
received in the auto stereo mode.
TUNED: Lights when a broadcast is received.
AM/FM: Light to indicate the current band (FM or
AM).
Displays & Controls
12
13
VOLUME
dB
TAPE 2
2
/dts mode on the
2
2
/dts mode on the
/dts mode on the receiver is
25