Setting The Volume Level Of Each Channel; Coaxial/Optical Digital Input Setting - Pioneer VSX-D510 Operating Instructions Manual

Coaxial digital input setting
Here you tell the receiver what component you have
hooked up to the coaxial digital input jack.
Press % or fi to select the coaxial digital
input (DVD, TV, CD, CD-R, VCR or OFF).
After you assign a component to the digital jack,
whenever you select that component, for example a
DVD player, the receiver will automatically change to
the digital input setting. You can see this in the
DIGITAL/ANALOG indicator on the front of the
receiver.
MEMO:
• The initial setting is "
DVD
Optical digital input setting
Here you tell the receiver what component you have
hooked up to the optical input jack.
Press % or fi to select the optical digital
input (DVD, TV, CD, CD-R, VCR, or OFF).
After you assign a component to the digital jack,
whenever you select that component, for example a
DVD player, the receiver will automatically change to
the digital input setting. You can see this in the
DIGITAL/ANALOG indicator on the front of the
receiver.
MEMO:
• The initial setting is "
CD
Setting the Volume Level of
Each Channel (adjusting the
speaker volume balance)
Use to set the relative volume of each channel.
".
".
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR
1
RECEIVER TUNER
2
2
DSP MODE MIDNIGHT 5.1CH
1
CHANNEL TEST
SELECT TONE
5
CHANNEL
LEVEL
9
5
FUNC
VOL
ST
MENU
SOURCE CLASS
D.ACCESS
1
LOUDNESS FUNCTION MUTING
RECEIVER
DIMMER
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1 Press .
RECEIVER
This switches the remote to the receiver mode.
2 Press 2.
3 Press or to adjust the volume to an
VOL + –
appropriate level.
4 Press
TEST TONE
The test tone is output in the following order.
(depending on the speaker setting mode)
FL
SW
• Test tone is only output in Dolby/DTS modes.
5 Adjust speaker levels so that you hear the
test tone at the same volume from each
speaker when seated in the main listening
position.
• The channel level range is ± 10 dB.
• Levels can be set for each surround mode.
6 Press
TEST TONE
MEMO:
• Since the SUBWOOFER transmits an ultra-low
frequency its sound may seem quieter than it actually
is.
• The speaker volume can be adjusted without
outputting the test tone by pressing
or
LEVEL CHANNEL SELECT
• Initial setting is 0 dB.
Preparations
Î
CD
CD-R/
TV CONT
TAPE/MD
2 3 4
SIGNAL 4,6
ATT SELECT
6 7 8
EFFECT
‡
0
ENTER
10 DISC
CH
TV CONTROL
VOL
FQ
ST
ENTER
TOP
MENU
FQ
MPX BAND
7 8 3
CHANNEL
¡ 4 ¢
3
FL REMOTE MASTER
SETUP VOLUME
to output the test tone.
CT FR
SL SR
to turn off the test tone.
CHANNEL
.
17
En