SRAM RSC Service Manual page 27

4 Use a torque wrench and a T10 TORX® bit socket to tighten each pivot
bolt to 2.7-3.2 N·m (24-28 in-lb).
5
Press the bladder into the reservoir cap, make sure the bladder is
properly seated into the reservoir cap. The bladder should be flush
with the cap.
6 Insert the reservoir cap/bladder assembly onto the lever body.
7 Install the detent ball followed by the detent spring into the lever body
reservoir hole closest to the lever blade.
T10 TORX bit 2.7-3.2 N•m (24-28 in-lb)
Lever Blade Installation 27
22 m