SRAM RSC Service Manual page 24

7 Place the SwingLink™ onto the SRAM Guide™ Lever Internals Assembly
Tool to adjust the length of the push rod on the SwingLink.
8 Use a 2 mm hex wrench to tighten the push rod into the SwingLink.
9
Use a 2 mm hex wrench to remove the SwingLink from the SRAM
Guide Lever Internals Assembly Tool and place the pushrod into the
coupler sleeve.
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
2 mm hex wrench
2 mm hex wrench
2 mm hex wrench
Piston Assembly Installation 24