Safety; Instructions To Oems; Radio Frequency (Rf) Safety; Electronic Devices - Multitech SocketModem EDGE Developer's Manual

Safety

Instructions to OEMs

The Multi-Tech product manual includes specific warnings and cautions in order to ensure that OEMs are aware
of their responsibilities, with regards to RF exposure compliance, for products into which the modem is
integrated. With this guidance, the OEM will be able to incorporate into their documentation the necessary
operating conditions and warnings.
OEMs need to provide a manual with the ''final'' product that clearly states the operating requirements and
conditions and that these must be observed to ensure compliance with current FCC RF exposure requirements /
MPE limits (see the "RF Exposures" section below). This will enable the OEM to generate (and provide the end-
user with) the appropriate operating instructions, warnings and cautions, and/or markings for their product.
FOR THE EFFICIENT AND SAFE OPERATION OF YOUR E-GPRS
INTEGRATED MODEM, READ THIS INFORMATION BEFORE USE.

Radio Frequency (RF) Safety

General
Your SocketModem is based on the EGPRS standard for cellular technology. The standard is spread all
over the world. It covers Europe, Asia, and some parts of America and Africa. This is the most used
telecommunication standard. Your modem is actually a low power radio transmitter and receiver. It
sends out and receives radio frequency energy. When you use your SocketModem integrated modem,
the cellular system, which handles your calls controls both the radio frequency and the power level of
your cellular modem.
Exposure to RF Energy
There has been some public concern about possible health effects of using GSM modems. Although
research on health effects from RF energy has focused on the current RF technology for many years,
scientists have begun research regarding newer radio technologies, such as GSM. After existing
research had been reviewed, and after compliance to all applicable safety standards had been tested, it
has been concluded that the product was fitted for use. If you are concerned about exposure to RF
energy there are things you can do to minimize exposure. Obviously, limiting the duration of your calls
will reduce your exposure to RF energy. In addition, you can reduce RF exposure by operating your
cellular modem efficiently by following the below guidelines.
Efficient Modem Operation
For your modem to operate at the lowest power level, consistent with satisfactory call quality:
•
If your modem has an extendible antenna, extend it fully. Some models allow you to place a call with
the antenna retracted. However your modem operates more efficiently with the antenna fully
extended.
•
Do not hold the antenna when the modem is IN USE. Holding the antenna affects call quality and
may cause the modem to operate at a higher power level than needed.
Antenna Care and Replacement
Do not use the modem with a damaged antenna. If a damaged antenna comes into contact with the
skin, a minor burn may result. Replace a damaged antenna immediately. Consult your manual to see if
you may change the antenna yourself. If so, use only a manufacturer-approved antenna. Otherwise,
have your antenna repaired by a qualified technician. Use only the supplied or approved antenna.
Unauthorized antennas, modifications, or attachments could damage the modem and may contravene
local RF emission regulations or invalidate type approval.

Electronic Devices

Most electronic equipment, for example in hospitals and motor vehicles, is shielded from RF energy.
However, RF energy may affect some improperly shielded electronic equipment.

Vehicle Electronic Equipment

Check your vehicle manufacturer representative to determine if any on-board electronic equipment is
adequately shielded from RF energy.

Medical Electronic Equipment

Consult the manufacturer of any personal medical devices (such as pacemakers, hearing aids, etc.) to
determine if they are adequately shielded from external RF energy. Turn your modem OFF in health care
facilities when any regulations posted in the area instruct you to do so. Hospitals or health care facilities may
be using RF monitoring equipment.
Multi-Tech Systems, Inc. SocketModem EDGE Embedded Wireless Modem Developer's Guide (S000376A)
Chapter 1 – Product Description and Specifications
IMPORTANT!
6