Using The [Tap/Ctl] Switch To Control The Effect - Boss MD500 Owner's Manual

Using the [TAP/CTL] Switch to Control the Effect

By default, the [TAP/CTL] switch is used for tap input, but you can change the setting and use this
switch to vary the way in which the effect is applied.
1
Press the [EDIT] button.
Use the [ H ] [ I ] buttons to select "CONTROL" and then press the
2
[EDIT] button.
Use the [ H ] [ I ] buttons to select a parameter, and use the [RATE/
3
VALUE] knob to edit the value.
Parameter
TAP/CTL
TAP/CTL PREF
TAP/CTL Settings
Value
OFF
TAP
RESET
MOMENT
BANK UP
BANK DOWN
4
Press the [EXIT] button to return to the top screen.
Value Explanation
Specifies the function of the [TAP/CTL] switch.
PATCH Different settings can be made for each patch.
SYSTEM The same settings are shared by all patches.
Explanation
No assignment.
Lets you specify the modulation rate by tap input.
When you press the pedal, the LFO's phase returns to the value of INIT PHASE (p. 10).
Outputs the effect sound only while you hold down the switch.
Change banks.
Basic Operation
7