Editing: Effects; Basic Procedure For Effect Editing; Effect Placement - Boss GT-1000CORE Owner's Manual

Editing: Effects

Basic Procedure for Effect Editing

The edit screens show the block configuration (effect chain) of
all effects provided by the GT-1000CORE, as well as the output
and send/return. You can edit from this effect chain display by
selecting the block that you want to edit.
1.
Press the [EFFECT] button.
The edit screen (effect chain) appears.
2.
Turn knob [SELECT] to select the block that you want to edit.
The selected block is enclosed by a thick frame.
* By pressing knob [SELECT] you can turn the selected effect
on/off. Effects that are off are shown in gray. When the effect is
turned on, it is shown in white.
Off On
3.
Use knobs [1]–[5] to adjust the parameters that are shown
below the screen.
Use the PAGE [ K ] [ J ] buttons to switch between the
parameters that you want to edit. The current page is
indicated in the lower center of the screen.
* To change a value in larger steps, turn a knob while pressing it.
* The number of parameters and pages differs depending on
the effect.
6
Editing while viewing all parameters
From the edit screen, you can long-press knob [SELECT] to see
a list of all parameters of the selected block. You can edit the
parameters from this list.
1.
Turn the [SELECT] knob to select the item that you want to
set.
Turning the knob will move the selected item vertically.
2.
Turn knobs [1]–[6] to edit the value of the parameters
shown in the screen.
Use the PAGE [ K ] [ J ] buttons to switch between lists of
parameters.

Effect Placement

By moving blocks such as effects, output, and send/return, you
can freely change the order in which the effects are placed, or
arrange them in parallel.
Changing the placement of effects etc.
1.
Press the [EFFECT] button.
The effect chain is shown.
2.
Use knob [SELECT] to select the block that you want to
move.
3.
While pressing knob [SELECT], turn it left or right.
The selected block moves left or right.