Clean And Sterilize; Assemble - Philips AVENT SCF902 User Manual

4 Clean and
sterilize
Before you use your breast pump for
the first time and for every time, you
must disassemble, wash, and sterilize all
the breast pump parts that come into
contact with your breast milk. (see b,
c, d, e, g, i in Overview
chapter)
Before you use the bottle and its parts
for the first time and for every time,
you must also disassemble, wash and
sterilize. (see l, m, n, o, p in
Overview chapter)
Warning
•
Never wash or sterilize the pump motor,
the silicone tube, the cap, and the power
adapter. These components do not come
into contact with your breast milk. You
can wipe the pump motor clean with a
soft cloth.
You can also use the dishwasher (top
rack only) or hand wash in warm, soapy
water, and then rinse thoroughly.
We recommend you to sterilize all the
necessary parts in our Philips AVENT
steam sterilizer, or by boiling for 5
minutes.
Caution
•
Take care when cleaning the valve and the
silicone diaphragm. If it gets damaged, your
breast pump will not function properly.
•
To clean the valve, rub it gently between
your fingers in warm soapy water. Do not
insert objects as this may cause damage.
5

Assemble

To assemble the pump, follow the steps
below.
Note
•
Make sure that you clean and sterilize the
pump as instructed in this user manual.
•
Make sure that you assemble the pump
correctly as instructed in this user manual.
•
To avoid leakage remove the residue around
the rim before assembling. Put the bottle
onto the pump body, and do not over-tighten.
•
Wash your hand thoroughly before you take
sterilized components.
1
Insert the valve into the pump body
from underneath.
2
Put the bottle onto the pump body
and turn it anticlockwise to fix it. Do
not over-tighten when assembling
the bottle to the pump body.
EN 6