To Enter Remote Start Mode; To Exit Remote Start Mode Without Driving The Vehicle; To Exit Remote Start Mode And Drive The Vehicle; Cancel Remote Start - Dodge Challenger 2016 Operating Information Manual

• Remote Start Disabled — Start Vehicle To
Reset
The instrument cluster message stays active
until the ignition is cycled to the ON/RUN posi-
tion.

To Enter Remote Start Mode

Push and release the REMOTE
START button on the RKE trans-
mitter twice within five seconds.
The vehicle doors will lock, the
parking lights will flash, and horn
will chirp twice (if programmed).
Then, the engine will start and the vehicle will
remain in the Remote Start mode for a 15-
minute cycle.
NOTE:
• If an engine fault is present, the vehicle
will start and then shut down 10 seconds
later.
• The park lamps will turn on and remain on
during Remote Start mode.
20
• For security, power window and power
sunroof operation (if equipped) are dis-
abled when the vehicle is in the Remote
Start mode.
• The engine can be started two consecu-
tive times with the RKE transmitter. How-
ever, the ignition must be activated by
pushing the START/STOP button twice (or
the ignition must be placed in the ON/RUN
position) before you can repeat the start
sequence for a third cycle.
To Exit Remote Start Mode Without
Driving The Vehicle
Push and release the REMOTE START button
one time or allow the engine to run for the entire
15-minute cycle.
NOTE:
To avoid unintentional shut downs, the sys-
tem will disable the one time push of the
REMOTE START button for two seconds
after receiving a valid Remote Start request.
To Exit Remote Start Mode And
Drive The Vehicle
Before the end of 15-minute cycle, push and
release the UNLOCK button on the RKE trans-
mitter to unlock the doors, or unlock the vehicle
using Passive Entry via the door handles, and
disarm the Vehicle Security Alarm (if equipped).
Then, prior to the end of the 15-minute cycle,
push and release the START/STOP button.
NOTE:
For vehicles equipped with the Keyless
Enter-N-Go feature, the message "Remote
start active - Push start button" will display
in the Driver Information Display (DID) until
you push the START button.

Cancel Remote Start

Remote Starting will also cancel if any of the
following occur:
• The engine stalls or engine speed exceeds
2500 rpm.
• Any engine warning lights come on.
• Low Fuel Light turns on.
• The hood is opened.