Dodge Challenger 2016 Operating Information Manual page 172

lection, press the "Rear ParkSense Vol." button
on the touchscreen, until a check-mark appears
next to setting, indicating that the setting had
been selected. ParkSense will retain its last
known configuration state through ignition
cycles.
• Blind Spot Alert — If Equipped
When this feature is selected, the Blind Spot
Alert feature Provides alerts, visual and/or au-
dible, to indicate objects in your blind spot. The
Blind Spot Alert feature can be activated in
"Lights" mode. When this mode is selected, the
Blind Spot Monitor (BSM) system is activated
and will only show a visual alert in the exterior
mirrors. When "Lights & Chime" mode is acti-
vated, the Blind Spot Monitor (BSM) will show a
visual alert in the exterior mirrors as well as an
audible alert when the turn signal is on. When
"Off" is selected, the Blind Spot Monitor (BSM)
system is deactivated. To change the Blind Spot
Alert status, press the "Off," "Lights" or "Lights &
Chime" button on the touchscreen.
NOTE:
If your vehicle has experienced any damage in
the area where the sensor is located, even if the
fascia is not damaged, the sensor may have
become misaligned. Take your vehicle to an
authorized dealer to verify sensor alignment.
Having a sensor that is misaligned will result in
the BSM not operating to specification.
• ParkView Backup Camera Active Guide-
lines
Your vehicle may be equipped with the
ParkView Rear Back Up Camera Active Guide-
lines that allows you to see active guidelines
over the ParkView Back up camera display
whenever the gear selector is put into RE-
VERSE. The image will be displayed on the
radio touchscreen display along with a caution
note to "check entire surroundings" across the
top of the screen. After five seconds, this note
will disappear. To make your selection, press
the "ParkView Backup Camera Active Guide-
lines" button on the touchscreen, until a check-
mark appears next to setting, indicating that the
setting had been selected.
• ParkView Backup Camera Delay
When the vehicle is shifted out of REVERSE
(with camera delay turned OFF), the rear cam-
era mode is exited and the navigation or audio
screen appears again. When the vehicle is
shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic
grid lines will be displayed for up to 10 seconds
after shifting out of "REVERSE" unless the
forward vehicle speed exceeds
(12 km/h), the transmission is shifted into
"PARK" or the ignition is switched to the OFF
position. To set the ParkView Backup Camera
Delay press the "Controls" button on the touch-
screen, the "settings" button on the touch-
screen, then the "Safety & Driving Assistance"
button on the touchscreen. Press the "Parkview
Backup Camera Delay" button on the touch-
screen to turn the ParkView Delay ON or OFF.
• Rain Sensing Auto Wipers
When this feature is selected and the wipers are
on, the system will automatically activate the
windshield wipers if it senses moisture on the
windshield. To make your selection, press the
"Rain Sensing Auto Wipers" button on the
8 mph
169