Matching Box - Furuno FE-800 Installation Manual

9. Turn on the power switch.
Power switch
Set the power switch to On to acti-
vate the Transceiver unit. The de-
fault setting is Off.
Note: For maintenance, the power
switch should be Off.
10. Close the covers.
Grounding
Attach the supplied copper strap between
the fixing plate on the unit and the ship's
ground.
Note: Ground the equipment to prevent
mutual interference.
2.5

Matching Box

The Matching box should be selected depending on the transducer type;
• 50B-6B transducer: MB-502
• 200B-8B transducer: MB-504
1. Remove four screws to open the top cover.
2. Unfasten the cable glands for both the transceiver unit and the transducer, then
remove the gaskets and washers.
Transducer side
- Cable gland
- Two flat washers
- Gasket
The cable gland closest to the
FURUNO logo is for the Transceiver
unit.
16
2. WIRING
Power switch (toggle)
ON
OFF
(Default setting)
Fixing plate Fixing plate
Copper strap
Transceiver unit side
- Cable gland
- Three flat washers
- Gasket