Table of Contents
Advertisement
3.
ADJUSTMENTS
This section provides the procedures for initial set up of the equipment.
3.1
Service Menu
This [Service Menu] settings should be properly set before operating the equipment.
Press the POWER key while pressing any key to open the [Service Menu].
Menu
[FE-8010 Serial
No.]
[FE-8020
CONFIG]
[FE-8020 No.1
Setup],
[FE-8020 No.2
Setup]
[DISP Order]
[External KP]
[Random KP]
[TX Mode]
[B Volt]
Service Menu
The serial no. for FE-8010 is shown.
When the second transceiver unit is connected, select [No.1 only] or
[No.1&No.2].
The setting for the transceiver unit.
[Serial No.]: The serial no. of selected transceiver unit is shown.
[FORE], [AFT]:
• [XDR]: Set the frequency.
• [KEEL]: Set the distance from the transducer to the keel.
• [Bottom Detect]: Set the depth from which to start detection of the
bottom.
• [Tx Count Reset]: Reset the TX count to zero.
[FAN0]:
• [FAN Limit]: Enter half of the fan rotation speed.
• [FAN Reset]: Reset the working hours of the fan.
For dual frequency display, select the transducer to display in the left
and right displays.
Select [ON] to output the external KP to the other device.
Reduces interference. Turn [ON] in normal use.
To take soundings properly the setting must be set to [ON].
Note:
appears at the bottom-right corner of the screen when
TX OFF
FE-800 is turned on with the [OFF] setting.
Set the voltage for B voltage. Select [Low] for normal use.
19
Scroll with the ▼ key
to show the hidden
menus.
Contents
FAN
FAN
Hide quick links:
Advertisement
Table of Contents
