Hd30/Hdp20 Series Assembly; Hd30/Hdp20 Series Disassembly - JLG 450A series II Service And Maintenance Manual

HD30/HDP20 Series Assembly

1. Grasp contact (1) about 25mm behind contact crimp
barrel.
2. Hold connector with rear grommet (2) facing you.
1
Figure 7-22. HD/HDP Contact Installation
3. Push contact straight into connector grommet until a
positive stop is felt. A slight tug will confirm it is locked
in place.
Figure 7-23. HD/HDP Locking Contacts Into Position
NOTE: Insert sealing plugs in unused wire cavities for full environ-
mental sealing.
3121290
SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS

HD30/HDP20 Series Disassembly

1. With rear insert toward you, snap appropriate size
2. Push tool in the insert cavity (2) until it engages contact
2
3. Pull contact-wire assembly out of connector
NOTE: Do Not twist or insert tool at an angle.
– JLG Lift –
extractor tool (1) over wire of contact to be removed.
and resistance is felt.
1
Figure 7-24. HD/HDP Contact Removal
Figure 7-25. HD/HDP Unlocking Contacts
2
7-9