Table of Contents
Advertisement
Operation Instructions
Startup screen: the startup screen will show the software
version, communication protocol, machine address, and
transmission baud rate, etc.
Activate OSD Menu
The method to activate the OSD menu may differ
depending on the connected keypad controller. For a
keypad controller that is compatible with Pelco D
keypad controller, press the number keys "95," and then
press and hold the "Set Preset" key for 2 seconds to
activate the OSD menu. For other special functions and
key combinations, refer to the table on Page 26.
Horizontal Pan/Vertical
Tilt
Manual horizontal pan
Manual horizontal pan must be controlled through the
joystick on the keypad controller. The rotation speed is
adjustable between 0.1° ~ 120°/sec by the position of the
joystick, and the maximum manual horizontal pan speed
is up to 120°/sec.
Manual vertical tilt
Manual vertical tilt speed is adjustable between 0.1° ~
90°/sec, and the speed will be restricted in Proportion
P/T mode.
Horizontal pan range
Vertical tilt range
Manual vertical tilt speed
Manual horizontal pan speed
Preset maximum rotation
speed
1) When 92° is used, the unit itself may appear on the
monitoring screen or deformation may appear on the
top of the screen. It is not a malfunction.
At that time, decrease the vertical angle, or zoom in to
eliminate this kind of phenomenon.
360° continuous rotation
1)
92°
0.1° ~ 90°/s
0.1° ~ 120°/s
Horizontal: 430° /s
Vertical: 200° /s
Scan function
Auto Scan
Auto scan can be configured to run at startup, or can be
controlled by the keypad controller (for details, see the
table on Page 26).
When the scan range has not been set
The camera will rotate horizontally until a command
from the keypad controller is receivied (e.g., horizontal
rotate, vertical rotate, iris, focus, etc).
When the san range has been set
The camera will rotate horizontally in the scan range
until a command from the keypad controller is received
(e.g., horizontal rotate, vertical rotate, iris, focus, etc).
For details on configuring the scan range, use the menu
command <PAN/TILT SETUP> scan limit stops.
FOCUS
During startup, the lens will zoom out to the minimum
ratio. When auto scanning is controlled by the keypad
controller, original zoom level will be maintained.
Tilt angle
During startup, the camera will perform vertical
scanning according to the tilt angle setting. For details
on configuring the tilt angle, use the menu command
<OTHERS> scan tilt angle. When the keypad controller
issues an auto scanning command, the tilt angle will
remain at the original setting.
Frame Scanning
Frame scanning can be configured to run at startup, or
can be controlled by the keypad controller (for details,
see the table on Page 26). Configuring the zoom level
and tilt angle is the same as in auto scanning.
When the scan range has not been set
The camera will scan at 45° increments until a command
from the keypad controller is received (e.g., horizontal
rotate, vertical rotate, iris, and focus etc). Refer to the
diagram below.
Activate OSD Menu / Horizontal Pan/Vertical Tilt / Scan function
(stop time)
7
Advertisement
Table of Contents
