Trouble Check; Operation - Sony Handycam DCR-VX700 Operation Manual

MGE
Trouble Check
If vou run into any problem using the camcorder, use the following table to troubleshoot the problem.
Camcorder
Power
Symptom Cause and/or Corrective Actions
The power is not on.
Insert the battery pack. ip œ
The battery is dead
3 Use a charged battery pack Gp. 4)
Connect the AC power adaptor to a wall outlet. (p. 20)
The power goes off.
While being operated in CAMERA mode, the camcorder has
been in the Standby mode tor more than 5 minutes.
> Turn STANDBY down once and turn it up again. (p. 12)
The batterv pack is quickly
discharged.
The batterv is dead.
> Use a charged battery pack. (p. 6)
The ambient temperature is too low. (p. 50)
Charge the battery pack agam. (p. 6)
The battery pack is campletely dead and cannot be
recharged.
2 Use another battery pack. (p. 51)
Operation
Symptom Cause and/or Corrective Actions
START/STOP does not operate. * The tape is stuck to the drum.
3 Eject the tape. (p. 9)
* Rewind the tape or use a new one. (p. 17)
* Set the POWER switch to CAMERA. (p. 11)
* The tab on the cassette is out (red).
> Usea new tape or slide the tab. (p. 10)
* Set the Standby switch to STANDBY. (p. 11)
The cassette cannot be removed from the * Insert the battery pack. (p. 8)
holder. * The battery is dead.
> Use a charged batterv pack or the AC power adaptor.
(p. 6, 20)
No function except for cassette ejection * Moisture condensation has occurred.
works. 2 Remove the cassette and leave the camcorder for at least
an hour. (p. 53)
The tape does not move when a tape * Set the POWER switch to VTR. (p. 17)
transport button is pressed. * Rewind the tape or use a new one. (p. 17)
* The camcorder is updating the cassette memorv
data (The cassette memorv mounted miniDV
cassette only).
3 Eject the cassette after C MEMORY indicator disappears.
(p. 9)
The STEADY SHOT function does not * Set STEADY SHOT to ON. ip. 40)
activate.
3 »peu» alqnosL/peoigy Japsorwes uno, Busy
57