Hardware Options Installation; Server Quickspecs; Introduction; Processor And Fan Option - HP ProLiant DL380 Gen9 Server User Manual

Hardware options installation

Server QuickSpecs

For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/servers/dl380gen9/qs).

Introduction

If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.

Processor and fan option

The server supports single-processor and dual-processor operations.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
IMPORTANT:
installing the processor.
To install a processor:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 24).
o
Remove the server from the rack (on page 25).
o
Remove the access panel (on page 25).
4.
Remove the air baffle (on page 31).
5.
Remove the processor blank.
6.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
If installing a processor with a faster speed, update the system ROM before
Hardware options installation 40