Alfa Romeo 4C Alpine Radio 2018 Manual page 46

System 1:
Subwoofer level changes according to the main vol-
ume setting.
System 2:
Subwoofer level change is different from the main
volume setting. For example, even at low volume
settings, the subwoofer is still audible.
Setting The Time Correction Unit (TCR Parameter)
You can change the unit, (cm or inch) of time correction.
• Setting item: TCR Parameter
Setting contents:
cm (Initial setting) / inch
cm: Time correction value is in centimeters.
inch: Time correction value is in inches.
Adjusting The Time Correction (T.Correction)
Before performing the following procedures, refer to
"About Time Correction" on page 48.
1. After selecting T.Correction from the Audio Setup
mode, turn the Rotary Encoder to select a speaker to
be adjusted, and then press
2. Turn the Rotary Encoder to adjust the distance of the
NOTE:
3. Repeat steps 1 and 2 to set another speaker.
/ENTER.
F-L*1 ↔ F-R*2 ↔ R-L*3 ↔ R-R*4 ↔ SSW-L ↔ SW-R
*1 Front-L
*2 Front-R
*3 Rear-L
*4 Rear-R
selected speaker, and then press
0.0 cm to 336.6 cm (3.4 cm/step)
0.0 inch to 132.7 inch (1.3 inch/step)
• The total adjustment distance for all speakers should
be less than 510 centimeters (201 inches).
By setting these values to make its sound reach the
listening position at the same time as the sound of
other speakers.
SOUND SETTING 45
/ENTER.
6