Co/Ip Preset Forward Attributes - iPECS eMG80 Administration Manual

Hide thumbs Also See for eMG80:

Table of Contents

iPECS eMG80 & eMG800 & UCP

Administration and Programming Manual

4.4.4.8 CO/IP Preset Forward Attributes - PGM 147

Selecting CO/IP Preset Forward Attributes will display the CO/IP Preset Forward Attributes data

input page. Enter a valid CO range and click [Load] to enter the CO/IP Preset Forward Attributes

data. Use the check mark to indicate which attributes to modify; data for checked attributes is

stored by clicking [Save] button.

Enter CO Range : eMG80: 1-74 / eMG800: 1-600 / UCP: 1-998

The CO/IP Preset Call Forward feature enables a CO line to initially ring at multiple stations and

forward to a pre-determined destination. A separate timer can be defined for each CO/IP line for

no-answer. The destination can be any index to the ICLID Ring Table in section 4.4.7.5 or a

Voice Mailbox. The VMID field allows selecting a specific mailbox when the CO line call forwards

to an external VM group.

Preset FWD Timer

Preset ICLID Ring Table

Preset VMID Digit

Figure 4.4.4.8-1 CO/IP Preset Forward Attributes

Table 4.4.4.8-1 CO/IP PRESET FORWARD ATTRIBUTES

An incoming call, which remains unanswered for

this timer, is routed as defined in the 'ICLID Ring

Table Index section'.

If an incoming call remains unanswered after the

Preset Fwd time above, the call is routed as

defined in the 'ICLID Ring Table index' defined

Each CO/IP line can be assigned a VMID (Voice

Mail Id) that is sent to the external VM group to

identify the desired Mailbox for the call.

(Max. 4 digits)